TM-2 Cutting Polishing Bench Lathe Lapidary Silversmithing Jewellery Making Trim Saw

$265.00 inc GST

Cutting Polishing Bench Lathe Lapidary Silversmithing Jewellery Making Trim Saw

1 in stock

Categories: ,

Description

This TM-2 bench lathe comes loaded with extras for lapidary and jewellery making.
It can be used with the table top for cutting and polishing or as a bench lathe by removing the 4 screws (picture 5).
Comes with a long list of extras.
  • 2 x 6″ Diamond notched saw blades for cutting stones.
  • 1 x 100mm cotton buffing wheel
  • 1 x 75mm  Velcro backing disk. 
  • 2 x split spindles. You cut a strip of the grit sandpaper you need and put the start in the slot of the spindle then wrap it around the spindle. This is used a lot in silversmithing and jewellery making.
  • 1 set of 105 pieces accessory kit for cutting grinding engraving shaping and polishing.
  • 1 x 30 piece diamond bur set
  •  5 x diamond drill bits. These bits have a tip that is diamond in matrix not just plated. This is the same as a sintered diamond wheel in that as it wears it exposes new diamonds.
  • 2 Tapered spindles can be attached to the 1/4″ motor shaft to accommodate buffing wheels.
  • 2 Threaded ends for use with wheels and buffs with 1/4″ hole.
  • Drill chuck
  • Flexi shaft (900mm long) with hand piece for holding burs, buffing wheels and drill bits
  • Pre-lubricated ball bearings and a dust proof housing for virtually maintenance free use.
  • Variable speed up to 10,000 rpm
  • 220v 350w

2 year Australian warranty Must be returned to Silversmithing Tools for warranty

Made in China

 

Reviews

There are no reviews yet.

Be the first to review “TM-2 Cutting Polishing Bench Lathe Lapidary Silversmithing Jewellery Making Trim Saw”

Your email address will not be published. Required fields are marked *